Fluorine-free vs C6 water-repellent finishes for textiles: how should you choose?
Short answer
Choose by whether the fabric genuinely needs oil repellency. Fluorinated (short-chain, C6-type) finishes deliver both water and oil repellency, which is essential for workwear and stain-release applications. Fluorine-free finishes deliver strong water repellency and stain resistance to water-based soils without any per- or polyfluoroalkyl substances, making them the default choice for outerwear, sportswear and home textiles where oil repellency is not required. For example, a fluorine-free water-repellent agent is applied at 40-80 g/L by padding, while a tri-proof (water/oil/stain) fluorochemical finish is applied at 10-80 g/L depending on the target level.
What each chemistry actually delivers
Fluorine-free water-repellent agents (typically dendritic or hyper-branched polymer chemistries) lower the fabric surface energy enough to repel water and water-based stains. On cotton, rayon, polyester, nylon and their blends they deliver strong water and stain repellency with good wash durability, and they leave the fabric handle and the dyeing and rubbing fastness essentially unchanged.
Fluorinated tri-proof finishes add oil repellency on top: on cotton, polyester and nylon fabrics they give water, oil and stain repellency in one bath, and combined with a cross-linking agent they survive up to 30 home launderings, with only a slight effect on handle and colour fastness.
Selection by end use
Choose fluorine-free when the buyer brief says "water repellent", "PFAS-free" or lists eco standards: outerwear, softshell, umbrellas, bedding and sportswear. Brand-side restricted-substance policies increasingly push this direction, and a fully fluorine-free recipe removes the PFAS question entirely.
Choose a C6-type tri-proof finish only when oil-based stains matter — restaurant workwear, medical textiles, seat covers. If oil repellency is not tested in your buyer specification, you are paying for performance the garment will never be graded on.
Process notes that decide the result
Water repellency lives and dies on preparation: residual surfactant and dyeing auxiliaries on the fabric are the main cause of a poor spray rating. Thorough scouring after dyeing, then padding the repellent at the specified pickup, then correct curing, are the three checkpoints. Both chemistries are cationic and water-dilutable, so keep anionic auxiliaries out of the same bath unless compatibility has been checked.
Key data from the TDS
| Product | Typical dosage | Appearance | Ionic character | Solubility |
|---|---|---|---|---|
| Fluorine-free Water-repellent agent NFC | 40-80g/L | Milky white liquid | Cationic | Can be diluted with water in any proportion |
| Tri-proof Finishing Agent FC6 | 10-80g/L | Milky white liquid | Cationic | Can be diluted with water in any proportion |
Full specifications, application instructions and packaging: see the linked TDS pages.
About CRYSL
Guangdong CRYSL New Materials Co., Ltd. is a textile auxiliary manufacturer based in Xintang, Zengcheng, Guangzhou, China, producing pre-treatment, dyeing and after-treatment, and functional finishing auxiliaries. The product range is certified under OEKO-TEX ECO PASSPORT and conforms to ZDHC MRSL V3.1 Level 3. Samples, TDS/COA documents and application support are available on request.
Contact: Ms. Luo · [email protected] · +86 186-7586-4963 · crysl.com.cn